S80 L6-2.9L VIN 92 B6294S2 (2004)
-
Remove the screws (1). Remove the bracket (2). The bracket will not be used again.
-
Install masking tape on the outside of the bumper to avoid damage from the saw. Leave the masking tape in place throughout the installation
procedure
-
Cut out along inside of the flange (1), on the underside of the bumper, so that the flange stays in place in the bumper
-
After cutting, even off the edges using a file.
-
Remove the tow hitch. First turn the handle (1) clockwise until a click is heard and the pin (2) is in the outer position. Pull the tow hitch straight
back.
Note! The shaft is greased.
Illustration A displays how the components for the hitch are assembled and mounted on the car body