S80 L6-2.9L VIN 92 B6294S2 (2004)
Power Seat Control Module: Service and Repair
Second Generation Power Seats
Power Seat Module (PSM), Replacing
Power seat module (PSM), replacing
Removing the control module
Raise the seat to its highest position.
For first generation power seats:
Remove the seat from the car. See Lifting seats in and out See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat/Lifting
the Front Seats In and Out.
For second generation power seats:
Remove the seat from the car. See Removing power seats, tilting See: Body and Frame/Seats/Service and Repair/Removal and Replacement.
Remove the key.
Note! The key must be removed to ensure that the ignition is not switched on by mistake.
Wait 1 minute before starting work.
Remove the two screws.
Disconnect the connector.
Remove the control module.
Installing the control module
Install:
-
the control module
-
the connector
-
the two screws. The seat must be tightened to the floor. Tighten to 48 Nm.