S80 L6-2.9L VIN 92 B6294S2 (2004)
Check that the mating surfaces on the propeller shaft CV joint and flange are clean.
Align the propeller shaft CV joint against the flange.
Install the screws loosely in the support for the centre bearing and the propeller shaft.
Install the propeller shaft using the marking made earlier.
Tightening the propeller shaft CV joint
Use new screws.
First tighten the screws crosswise to 8 Nm. Then tighten to 30 Nm.
Use counterhold 999 5743 Counterhold See: Tools and Equipment/999 5743 Counterhold.
Tighten the screws for the support for the centre bearing to 25 Nm.
Tighten the screws for the propeller shaft centre bearing to 25 Nm.
Installing the three-way catalytic converter (TWC)
Install the three-way catalytic converter (TWC) See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair.
Checking the oil level in the bevel gear
Check the oil level in the bevel gear
Use the right oil.