S80 L6-3.2L VIN 98 B6324S (2007)
Note! Take care to ensure that the activator has dried for at least ten minutes and maximum 30 minutes, before painting.
-
Paint the sensors with the same color code as the car. Use paint recommended by Volvo. Paint max. two layers (1 layer base coat and 1 layer clear
coat). Protect connections so that paint does not end up on the contact surfaces.
Caution! Too many layers of paint may result in partial or complete malfunction.
-
Turn the ignition switch to position 0.
Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.
-
Remove the four screws holding the end of the rear bumper.
Repeat the operation on the other side.