S80 L6-3.2L VIN 98 B6324S (2007)
-
Take the cable harness with the two rubber grommets from the kit. The rubber grommet (1) with the shorter cable end must go through the trunk
lid.
-
Hook the cable holder onto the inner lower edge of the hinge section.
Illustration B
-
Place the cable holder so that the stop in the upper edge locates in the cut-out on the hinge.
-
Press the cable holder so that the upper section engages in the upper edge of the hinge.
-
Insert the longer of the cables in the hole on the rear fender and press the rubber grommet securely into place. Ensure that the primer around the
hole edges is not damaged.
Note! Do not damage the rustproofing agent around the hole edges.
