S80 L6-3.2L VIN 98 B6324S (2007)
-
Thoroughly clean away splashes of underseal, putty or dirt from the plate surfaces on the insides of the side members where the reinforcements
shall be located.
-
Check that the contact surfaces inside the side members are clean, if not, clean them opposite where the towing member's side plates shall be
tightened.
-
Take the towing member from the kit and insert the two side plates in the holes in the rear edge of the side members.
-
Take screws and the reinforcement bar from the kit. Get assistance to hold and adjust the position of the towing member when the screws are
tightened into the towing member's weld nuts. The silencer and deflector plate need to be pressed down to allow the screws and reinforcement bar
to be positioned and torque tightened.
-
Tighten the screws alternately on both sides.
Tightening the screwed joint
