S80 L6-3.2L VIN 98 B6324S (2007)
-
Reinstall the shock-absorbing section above the impact member and tighten it in using the existing screws.
-
Reinstall the connector and cable to the shock-absorbing section above the impact member.
-
Apply tape to the outside of the bumper cover, opposite the markings on the inside and right up to the first joint line on the lower section of the
bumper cover. This is in order to protect the paintwork from the base of the saw when sawing out the cut-out for the towbar.
-
Cut out the cut-out following the existing markings.
NOTE: Do not damage the painted surface of the bumper cover. Cut so that the raised edge on the inside remains. The raised edge marks the
cut-out.
-
Smooth off the sawn edges with a fine toothed file.
NOTE: Install the towbar connector with cable harness in accordance with the applicable installation instructions before reinstalling the bumper
cover.
