S80 L6-3.2L VIN 98 B6324S (2007)
-
Tighten the screws to 90 Nm (66.5 lbft.) and angle tighten to 60°.
When angle tightening screwed joints in a confined spaces, a protractor, applied to the torque wrench, cannot be used. An Allen screw head is used to
determine the turning angle instead.
-
Make a mark on the flange of the screw head (1).
-
Make a second mark (2) on the reinforcement bar.
-
Now tighten the screw so that the screw head marking (1) lines up with the marking (2) on the reinforcement bar.
-
Repeat for all screws.
Applies to cars with twin rear silencers.
-
Reinstall the heat deflector plate and the rear mountings for the silencers. Torque tighten the mounting screws to 50 Nm (37 llbft.).
-
Carry out the equivalent operation on the left-hand side for cars with single rear silencer.
Illustration A
Applies to all models
-
Reinstall the exhaust system rubber mounting in the body above the front edge of the subframe.
Illustration A applies to vehicles with 8 cylinders, 6 cylinders and four wheel drive