S80 L6-3.2L VIN 98 B6324S (2007)
-
Plug the grey connector into the trailer module (TRM).
-
Take the ground screw from the kit and secure the ground lead to the ground terminal in the rear crossmember.
-
Torque tighten the screw, tightening torque: 10 Nm (7.5 lb.ft.).
-
Clamp the cable harness up beside the existing cable harness using two tie straps from the kit.
Checking the 4-pin connector
Note! The trailer module (TRM) must be programmed with software in order to function correctly.
-
Reinstall the connector and side panel in the cargo compartment.