S80 L6-3.2L VIN 98 B6324S (2007)
-
Disconnect the cable to the sensor.
-
Carefully pry up the tabs on the upper and lower side of the sensor holders using a small screwdriver, so that the catches on the sensor release and
the sensor can be pulled out.
-
Carefully press in the catches on the lower and upper side of the sensor holder and press out.
-
Remove the panel. It will not be used again.
-
Take the new panel from the kit and press the sensor holder into it. Ensure that the cut-out marked with an arrow is turned towards the outer edge
of the panel.
