S80 L6-3.2L VIN 98 B6324S (2007)
-
Wipe clean the protective tape on the spoiler's attaching tape before marking on the boot lid.
Get help from a colleague when marking the spoiler's rear position on the boot lid. The spoiler is slightly straighter than the curve on the boot lid, and
must be bent according to the markings on this for the marking to be correct.
-
Place the spoiler on the boot lid. Mark its position along the whole trailing edge with a whiteboard marker. The sideways position shall be
edge-edge (butt-to-butt) with the start of the radius in the boot lid.
-
Apply a 7 mm (9/32") wide bead of primer all the way around on the boot lid, 3 mm (1/8") inside the drawn lines.
Make sure that no primer ends up on other surfaces. If so, clean with isopropanol.
