S80 L6-3.2L VIN 98 B6324S (2007)
999 5746 Holder See: Tools and Equipment/999 5746 Holder
The piston's arrow (top of piston) shall point forward and make sure that the classification matches. Use piston ring compressor. Lube the cylinder bores,
pistons and bearings shells with oil. Turn the crankshaft so that the crank pin is at lower dead centre for the cylinder the piston is to be installed in. Make
sure that the engine hangs so that the cylinder bores are as vertical as possible.
Carefully press/tap down the piston (e.g., with a hammer handle). When the piston has released the piston ring compressor, turn the engine 180° in the
work stand. Tighten the connecting rod until it is fixed against the big-end bearing journal.
The crankshaft may not be rotated before the connecting rod's cap is tightened. Install the cap. Check that any marking matches. Lube the new screws
with oil and install them. Tighten the screws according to the following sequence
Torque: Cap connecting rodStage 1: 12 Nm Stage 2: 20 Nm Stage 3: 90 degree
Check that the connecting rods can be moved sideways.
Torque: M6, 10 Nm
Install the following items:
-
oil pump and line. Refer to: Oil pump, B6324S See: Engine Lubrication/Oil Pump/Service and Repair
-
oil sump. Refer to: Oil pan, B6324S See: Engine Lubrication/Oil Pan/Service and Repair
-
front crankshaft seal. Refer to: Crankshaft front seal, B6304T2, B6324S See: Seals and Gaskets/Front Crankshaft Seal/Service and Repair
-
rear crankshaft seal. Refer to: Crankshaft seal, rear, B6304T2, B6324S See: Seals and Gaskets/Crankshaft Main Bearing Seal/Service and Repair
-
other parts. Refer to: Engine block, installing components See: Service and Repair/Overhaul/Engine Block, Installing Components Engine block,
installing components See: Service and Repair/Overhaul/Engine Block, Installing Components Engine block, installing components, B6324S,
