S80 L6-3.2L VIN 98 B6324S (2007)
-
Install a new clip with tie strap, and two edge clips from the kit on the upper edge of the subframe.
-
Take a junction connector, joint cable for passenger compartment connector socket and three locking sleeves form the kit.
-
Use low temperature grease, part no. 1161427, to grease O-rings on:
-
the connector to the front engine block heater socket
-
both connectors on the junction connector
-
the connector to the joint cable for the passenger compartment connector socket
Note! Do not get any grease on the surfaces of the connector.
-
Take the locking sleeves from the kit.
-
Connect the cables in accordance with the following:
-
Cable (1) from the engine block heater.
-
Joint cable (2) to the passenger compartment connector socket.
-
Cable (3) from the front engine block heater socket.
-
Press the cables firmly into the junction connector and press the locking sleeves in over the cable splices.
