S80 L6-3.2L VIN 98 B6324S (2007)
-
Get two double strip clamps from the kit and fasten them on the engine mount on the right side of the engine's top.
-
Get the strip clamp and fit it loosely through the hole in the engine mount's front edge.
-
Get a strip clamp and two double clamps from the kit. Fit the strip clamp loosely around the console at the rear edge of the engine mount.
-
Install both double clamps on the return pipe to the power steering.
-
Route the cable to the passenger compartment connector and to the first installed strip clamp in the subframe's right front corner.
-
Tighten down the cable. Pull in excess cable in the passenger compartment.
Note! Do not clamp the cable directly to brake pipes, fuel lines, AC pipes or pipes to the power steering.
