S80 L6-3.2L VIN 98 B6324S (2007)
Applies to right-hand drive cars
-
Drill a - 5.5 mm (7/32 ") on the right side of the large rubber grommet as illustrated. Use an angle drill and fit a 5 mm (13/64 ") drill stop.
Note! Be careful not to drill into existing cables, pipes or other components.
Applies to right-hand drive cars
-
Unplug the engine block heater connectors. These are located on the right side near the brake servo.
Illustration A
Applies to right-hand drive cars
-
Take the adapter cable with two large connectors from the kit.
-
Plug in the adapter cable connectors to the corresponding engine block heater cable connectors that were unplugged before.
Illustration B