S80 L6-3.2L VIN 98 B6324S (2007)
-
Connect the red (R) cable from the timer relay to terminal 3, the red (R) cable from the cable harness from the kit to terminal 1, and the brown
(BN) cable to terminal 6 in the 6 pin connector. The yellow cable will no longer be used and must be taped to the cable harness. Depress the
secondary catch on the connector.
Synchronizing the Transmitter - Receiver
1. Connect the battery's negative lead.
2. Install batteries in the transmitter battery compartment.
3. Connect the connector and antenna cable to the receiver unit.
4. Within 5 seconds, press the "OFF" button on the transmitter until the LED goes out. Synchronization has been carried out.
-
Press the receiver unit onto the Velcro on the body plate if it has loosened.
-
Tape up any cable excess from the timer relay and place it next to the receiver unit under the insulation mat.
-
Reinstall the glovebox and tighten the M6 bolts to 10 Nm (7.5 lbf.ft).
-
Plug in the connector on the back of the glovebox and fit a new tie strap to the cable.
