S80 L6-3.2L VIN 98 B6324S (2007)
-
Install a tie strap with edge clip on the panel edge in the front edge at the left-hand front corner of the subframe.
-
Take two clips from the kit and install them on the upper edge of the subframe, and turned in toward the subframe U-profile. Install the clips
approximately in the positions illustrated.
-
Install a tie strap with clip in the hole in the upper edge of the subframe in order to clamp up any excess cable. The tie strap must be fitted turned
in toward the subframe U-profile
-
Drain the coolant.
-
Tighten the nipple after the coolant has been drained.
Applies to the XC60
