S80 L6-3.2L VIN 98 B6324S (2007)
-
Take the hose clamp from the kit and fit it onto the engine block heater's upper connection.
-
Position the engine block heater with bracket in the front edge of the oil sump and connect both hose-ends to the engine block heater's connections.
-
Take a screw from the kit and tighten the bracket with engine block heater into the existing hole in the oil sump.
Note! The screw is self-tapping so insertion may be slow. Make sure that the screw is centered straight into the hole, so that the screw
head is flat against the bracket.
-
Now adjust the engine block heater in the rubber coated clamp so that the hoses are properly fitted on the engine block heater's connections.
-
Tighten the screw to the rubber coated clamp.
-
Tighten the hose clamps to the engine block heater.
-
Install the double clamp to the cable for the alternator in the engine block heater's upper hose.
