S80 L6-3.2L VIN 98 B6324S (2007)
Applies to cars with pre-wired connector for 12V socket, but does not have cable harness along the rear trunk
-
Get four strip clamps with clips from the kit and press them into the holes in the rear trunk.
Note! Install the clamps so that the strip clamp is inserted from below.
-
Route the longer part of the cable harness along the rear trunk to the luggage compartment's right side.
-
Clamp down the cable harness with strip clamps.
Applies to cars with a 12V socket
-
Plug in the two-pin male connector (1) which was disconnected from the 12V socket to corresponding connection (2) in the routed cable harness.
Later the remaining connection in the routed cable harness is connected to the 12V socket when the side panel is reinstalled.
-
Clamp up the extra lead with a strip clamp.
Applies to cars without 12V socket
-
Connect the pre-wired two-pin connector (1) to corresponding connector (2) in the routed cable harness.
-
Clamp excess cable and extra connector with strip clamp.
Applies to cars without pre-wired connector for 12V socket
