S80 L6-3.2L VIN 98 B6324S (2007)
-
Connect the existing green 5-pin male connector (1) to the green 5-pin female connector (2) in the pre-routed cable harness.
-
Secure the excess cable (3) with a cable tie from the kit.
Applies to cars with trailer module (TRM) and/or parking assistance camera (PAC).
-
If the car is equipped with a trailer module (TRM), PAC or both: Disconnect the green male connector from the TRM/PAC and connect it to the
cable harness green 5-pin female connector. Connect the remaining male connector to TRM/PAC.
-
Clamp the pre-routed cable harness at the existing cable harness with four cable ties from the kit.
Steps 21-23 applies to cars without the pre-routed cable to the 12V socket
-
Secure the cable with the white 2-pin male connector (1) together with the relay (1), at the existing cable harness with cable ties from the kit.
-
The long cable with two green connectors (2) are rolled together and clamped at the existing cable harnesses.
-
Take the cable harness (B) from the kit and place it along the rear member with the two grey connectors and the fuse at the left-hand tail lamp.
-
Connect the white 2-pin male connector (3) in the newly routed cable harness to the white 2-pin male connector (4) in the cable harness that was
first routed.
