S80 L6-3.2L VIN 98 B6324S (2007)
Note! Take care to ensure that the activator has dried, at least ten minutes, before painting.
-
Paint the sensors the same color as the car. Use the recommended Volvo color. Paint a maximum of two coats. Protect the connections to prevent
painting the contact surfaces.
Caution! Too many layers of paint may result in partial or complete malfunction.
-
Turn the ignition switch to position 0.
Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.
-
Remove the four screws holding the end of the rear bumper.
Repeat the operation on the other side.