S80 L6-3.2L VIN 98 B6324S (2007)
-
Apply a thin and uniform layer of adhesive, part no. 9511027, to a holder. The adhesive must be slightly above the tape level.
Note! The adhesive must not come into contact with the tape.
The task of the tape is to secure the holders to the bumper casing until the adhesive has hardened after approximately 24 hours.
-
Install the centering tool in one holder.
-
Install the tool on the bumper cover.
-
Hold the holder securely when removing the centering tool. The holder must be installed horizontally and in line with the bumper cover.
-
Repeat the steps until all four holders are in place.
-
Connect the cable harness connectors to the sensors.
