Volvo Workshop Manuals
S80 FWD L6-3.2L VIN 94 B6324S4 (2011)
Sensors and Switches > Sensors and Switches - Wiper and Washer Systems > Rain Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 1289
How to Use the Wiring Diagrams
How to use the wiring diagrams
The descriptions below apply in general to all wiring diagram, although not all sections are necessarily contained in this information.
A. Component designation
Every component has a component designation that consists of two parts.
The first part is a type number that describes the type of component in question, for example 3/xx.
The second part of the designation is a serial number, e.g. x/2.
Together, this constitutes a component designation, e.g. 3/2.
At the end of the information is a list of components, where, with the help of the component designation, you can read off the name of the component, for
List of type numbers
The list shows which type of component that respective type numbers refer to, for example, 3/x = switch, 6/x = electric motor, etc.
Driver information module
Electrical distribution rail/box
The systems are shown in non active status, i.e. with key removed and when doors, hatches and hood are closed.
B. Branching points
The wiring diagrams contain numbered branching points, for example 73/5035.
This information contains a section with a list of branching points. This list shows all the components that are connected to each branching point.
The location of the branching points is shown in the "Cable harness routing in vehicle" section.
|[PREV PAGE] [NEXT PAGE]|