Volvo Workshop Manuals
S80 FWD L6-3.2L VIN 98 B6324S (2010)
Transmission and Drivetrain > Automatic Transmission/Transaxle > Band Apply Servo, A/T > Component Information > Technical Service Bulletins > Customer Interest for Band Apply Servo: > TJ21096 > Jun > 09 > A/T - Fluid Leaks From Servo Cover > Page 4029
If the automatic transmission fluid is leaking from the B1 servo cover (shown in photos), replace the cover and 0-rings according to the following
Note! Some variation in the illustrations may occur, but the essential information is always correct.
2. Drain the transmission of fluid according to VIDA:
Caution! Make sure that the area around the component is clean and free of foreign material.
Use: Cleaning agent, 1161721.
Caution! Observe cleanliness when handling the components.
Warning! Make sure that the vehicle does not lift off the hoist when using the transmission jack.
Use: Jack 9985972 and counterhold 9995656. Push the piston up and remove the locking ring.
Note! Use absorbent pads suitable for drying any fluid that runs out.
Lower the jack carefully and remove the cover, piston and spring.
Caution! It the piston is damaged, the transmission must be replaced.
|[PREV PAGE] [NEXT PAGE]|