S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Applies to all models
-
Clamp the cables in at the cable harness/cable duct on the left-hand side with a tie strap from the kit. Clamp in any excess cable neatly.
-
Connect the new routed DIN cable to the radio.
-
Plug in the other connectors which were detached from the radio.
-
Plug in the connectors for the phone keypad, if applicable.
-
Refit the radio.
-
Connect the connectors to the dashboard environment panel. Reinstall the dashboard environment panel.
-
Reinstall the panel and gear selector lever boot around the gear selector lever.
-
Fold back the carpet by the front seat.
-
Refit the centre console's side panel.
-
Refit the sill trim panel in the left front and rear door.
-
Reinstall the front and the new folding rear panel from the kit in the left-hand side of the cargo compartment.
-
Reinstall the side bolster.
-
Fold the backrest back into place.
-
Reinstall the seat cushion.
-
Turn the ignition key to position II.
-
Reconnect the battery negative lead.
-
Reposition the carpet in the cargo compartment.
Check that the system is working
-
Install the memory unit (DMS) in the Jukebox
-
Switch on the radio and select the 10-CD changer
Note! The first time the system is started it takes approx. 30 seconds before it is operational