S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
Route the cable harness from the tow bar connector through the hole in the floor
-
Adjust the position of the rubber seal (2) so that there is not too much slack in the cable under the car
-
Install the rubber seal in the hole
-
Route the cable as illustrated. Clamp in the existing cable harness in the sill trim panel. Ensure that the cable harness is not impeded by the battery
holder and the protective cover
-
Connect the cable harness connector (1) to the existing connector (3).
Applies to the V70 (00-) and V70XC (01-)
-
Route the cable harness from the tow bar connector through the hole in the floor
-
Adjust the position of the rubber seal (2) so that there is not too much slack in the cable under the car
-
Install the rubber seal in the hole
-
Route the cable as illustrated. Clamp in the existing cable harness in the sill trim panel. Ensure that the cable harness is not impeded by the battery
holder and the protective cover
-
Connect the cable harness connector (1) to the existing connector (3)
-
Secure the two connected connectors (4) in the existing hole in the bodywork.
Applies to the S80