S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Removing turbo 1 / manifold
Note! Clean and spray the exposed threads with rustproofing agent before beginning removal.
Remove the manifold mounting nuts on the engine.
Pull off and lift up the turbocharger (TC) / manifold.
Removing turbo 2 / manifold
(The car is not correct because the pulsed secondary air injection system (PAIR) pump has been discontinued.)
Note! Clean and spray the exposed threads with rustproofing agent before beginning removal.
Remove the manifold mounting nuts on the engine.
Pull off and lift up the turbocharger (TC) / manifold.
Note! The oil pressure pipe withdraws from the turbocharger (TC) / manifold at the same time.
Installing manifold / gasket
Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling See: Exhaust System/Exhaust Pipe/Service and Repair.
Replacing manifold
Transfer the turbocharger (TC) to the new manifold.
Lubricate the stud threads. Use paste, P/N: 116 1408. Avoid skin contact with the paste.
Install new nuts. Tighten to 25 Nm.
Replacing gasket