S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
There are two sizes of the cavity opening.
See illustration.
Choose a terminal removal tool with ends which match the cavity opening extraction groove.
-
The narrow ends are 1.5 mm wide.
-
The wider ends are 2.7 mm wide.
Press the cable terminal in the cavity forwards as far as it will go to free the locking tab from the cavity catch.
Insert the terminal removal tool in the groove as illustrated.
Always follow the instructions in When secondary locking is of the lid type which give the correct working procedure.
-
Proceed to chapter New cable terminal See: Diagrams/Diagnostic Aids/New Cable Terminal Seal sws and plug . Replacing a cable terminal in
order to crimp a new cable terminal.
Connector Brake Control Module (BCM), Repair
Connector Brake Control Module (BCM), repair
Special tools:951 2636 Terminal removal tool See: Tools and Equipment/951 2636 Terminal Removal Tool ,951 2639 Terminal removal tool See: Tools
and Equipment/951 2639 Terminal Removal Tool
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Connector, dismantling
Secondary lock