S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Control Arm Bushing: Service and Repair
Bushing Outer Control Arm Upper, Replacing
Bushing outer control arm upper, replacing
Special tools:
951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder
999 7030 Mounting bracket bushing replace See: Tools and Equipment/999 7030 Mounting Bracket Bushing Replace
999 7031 Locating pin See: Tools and Equipment/999 7031 Locating Pin
999 7035 Sleeve See: Tools and Equipment/999 7035 Sleeve
999 7036 Drift See: Tools and Equipment/999 7036 Drift
999 7038 Drift See: Tools and Equipment/999 7038 Drift
999 7039 Connecting rod M16X360 See: Tools and Equipment/999 7039 Connecting Rod M16X360
999 7054 Adapter incl. 2x MC6C M6X12 See: Tools and Equipment/999 7054 Adapter incl. 2x MC6C M6X12
Removal
Preparation
Remove the wheel.
Disconnecting the lateral link
-
Install the retaining strap and secure the lower control arm slightly against the jacking point
-
Remove the lateral link screw at the spindle
-
Slacken off the screw at the front mounting slightly. Turn the lateral link downwards.
Disconnecting the control arms
-
Install tensioner and tension the rear suspension to the normal position. See Tensioner, instructions for use, AW55-50/51SN, 4T65EV-GT See:
Service and Repair/Removal and Replacement/Tensioner, Instructions For Use
-
Remove the screw for the lower outer and upper control arm mounting.
Disconnecting the tie rod
-
Remove the tie rod outer mounting