S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Hang the steering gear from a hook 999 5045 COMPRESSION HOOK See: Tools and Equipment/999 5045 Compression Hook so that the lower
steering shaft does not come apart.
On right-hand drive cars the hook is installed on the right-hand side.
Transferring components
Transfer
-
the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm. Angle-tighten 90°. Use bevel protractor 951 2050
BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protactor. Tighten the rear screw. Tighten to 105 Nm. Angle-tighten 90°
-
the anti-roll bar. Tighten to 60 Nm
-
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm. Angle-tighten 60°
-
the mounting for the heated oxygen sensor (HO2S) wiring
-
the engine pad.
Install new pipe / hose holders.
Installing the sub-frame
-
Position the sub-frame on a lifting table
-
Carefully lift the sub-frame
-
Locate the control arms on the ball joints and the steering gear on its mountings
-
Remove the hook (999 5045) that is holding the steering gear
-
Lift the sub-frame up completely.