S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Note! In order to replace the lock-up solenoid, the oil pump must be removed from the control system. This is so that the spring clip holding the
solenoid can be accessed. The shiny screw (1) must not be removed, it holds the oil pump together.
Remove:
-
the temperature sensor with the cable harness from the clip
-
the connector from the solenoid. Fold the cable harness out of the way
-
the screws, not the shiny screws (1).
Note! The dimension of the upper screws.
Removing the oil pump from the pump shaft