S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Vent the boot
Venting is carried out to remove any over pressure in the boot. Use a rounded screwdriver.
Carefully insert the screwdriver between the drive shaft and boot. Ensure that the boot is in position on the drive shaft.
Ensure that the boot is aligned against the inner rib on the drive shaft.
Install a new clamp. Use pliers 951 2619 Pliers See: Tools and Equipment/951 2619 Pliers.
Install the drive shafts
For the left-hand side, see Half shaft, left, replacing See: Service and Repair/Half Shaft, Left, Replacing , Drive shaft left, replacing, B5254T2, M56
See: Service and Repair , Drive shaft left, replacing, B5254T2, M56 See: Service and Repair and Drive shaft left, replacing, B5254T2, M56 See: Service
and Repair.
For the left-hand side, see Transmission, installing See: Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/Gearbox,
Installing (cars with a viscous coupling), Drive shaft right, replacing See: Service and Repair/Drive Shaft Right, Replacing , Drive shaft left, replacing,
B5254T2, M56 See: Service and Repair , Drive shaft left, replacing, B5254T2, M56 See: Service and Repair and Drive shaft left, replacing, B5254T2,
M56 See: Service and Repair.
Spray wax, part number 30787812, on the outer gaiter. After installing drive shaft in vehicle, turn the wheel and check, and improve if needed, the wax
protection on the gaiter.