S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Headlamp Wiper Motor: Procedures
Wiper Arm And Wiper Motor, Headlamp, Replacing
Removal
Preparations
-
Switch off the ignition.
Headlamp wiper arm
-
Lift up the protective cover over the nut
-
Slacken off the nut a few turns. Leave the nut in place to protect the threads on the shaft journal
-
Remove the wiper arm from the shaft journal. Use a pipe wrench supported against the nut
-
Remove the nut and wiper arm
-
Disconnect the hose.
Headlamp wiper motor
-
Remove the headlamp wiper arm
-
Remove the radiator grille.
-
Remove Casing, bumper front
-
Remove Cover strip
-
Remove Shock absorbers
-
Remove Headlamp/bulb
-
Disconnect the connector for the headlamp wiper motor
-
Remove the 2 screws from the headlamp wiper motor
-
Remove the headlamp wiper motor.
Installation
Headlamp wiper motor
-
Position the headlamp wiper motor
-
Install the screws. First tighten the inner screw. Then tighten the outer screw. Tighten the screws. Tighten to: 8 Nm
-
Connect the connector
-
Install Headlamp/bulb
-
Install Shock absorbers