S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Clean around the sensor seat so that when installed the sensor will be in the correct position against the pulse wheel. Use a soft brush.
Install:
-
the sensor. Tighten the screw. Tighten to 10 Nm
-
the wiring in its brackets
-
the clips
-
the connector.
Check that the wiring is installed in the brackets and clips.
Install the wheel
See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair
Function test
Read off any diagnostic trouble codes (DTCs) stored in the control module. Erase.
Interrupt the diagnostic function by turning off the ignition.
Test drive the car
See Test Drive Form (ABS), description See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Drive Form (ABS), Description
Check that no diagnostic trouble codes (DTCs) are stored.
Interrupt the diagnostic function by turning off the ignition.