S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Install the split pin on the lever.
Tighten the locknut on the lever.
Remove the test equipment.
Insert the hose upwards following previous routing.
Install the lower splash guard.
Lower the car.
Checking / setting turbo2 pressure regulator
Preparation
Remove
-
the turbocharger (TC) intake pipe
-
the charge air pipe from the turbocharger (TC)
-
the heat deflector plate over the turbocharger (TC).
Connecting test equipment
-
Connect test equipment. See Connecting test equipment
Checking and adjusting push rod
-
Check and adjust the push rod. See Checking and adjusting push rod.