S90 L6-2.9L VIN 96 B6304S (1998)
5. Remove:
a. The wheels
b. Brake caliper. Hang calipers up with a wire to avoid stretching the hoses.
c. Screws to anti-roll bar in support arms.
d. Upper screws on the dampers, raise lifter unit slightly under wheel bearing housing when the screws are removed.
6. Position the lift unit in front edge on support arm as support.
Remove:
a. One of the front screws to the support arm bracket. Replace with an M10 screw approx. 85 mm long.
b. The two other screws and the nut.
c. Lower the lift, the long screw will hold the support arm. Repeat operations on the other side.
7. Position the lift unit with fixture under the rear axle beam. Remove:
a. Front screws to beam - body.
b. Screws to the rear brackets and screws to beam - body.
8. Carefully lower the rear axle beam approx. 100 mm.