V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Installation
Checking the control module
Caution: The seal surfaces must not be mechanically worked using a file or scraper.
Use a plastic tool. Never clean using a solvent.
Check that:
-
none of the pins or sockets on the connector are damaged
-
there is no dirt on the seal surfaces between the control module and the ABS hydraulic modulator
-
no part of the control module seals remain on the ABS hydraulic modulator valves.
Installing the ABS control module
-
Remove the transport protection on the new control module
-
Center the control module on the ABS hydraulic modulator valves before the valves are pushed into place
-
Carefully position the control module
-
Install the six Torx screws in the following two stages:
Tighten the screws. Tighten to 3 Nm.
Angle-tighten the screws 90°
-
Note: The torque must not exceed 8 Nm.
-
Connect the pump motor connector.
Installing the ABS hydraulic modulator and the control module
-
Carefully lower the control module and ABS hydraulic modulator.
The brake pipes will follow at the same time. Do not damage the brake pipes
-
Install the 3 rubber dampers and the 2 mounting lugs
-
Tighten the 2 mounting nuts. Tighten to 25 Nm (E).