V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Remove the driver side, under-dash panel covering the central electronic module (CEM).
Remove the connector (A) from the CEM.
4
Connecting the cable harness to the CEM
Open the catch (A) by pushing it out (approximately 2 mm) on the other side at points (B).
Insert terminal removal tool 951 2636 in terminal slot 4 and terminal slot 12 respectively as indicated in the illustration. Push the catch (C) to one side.
Remove the wire from the connector.
Connect the two wires from the auxiliary harness to slot 4 and 12 in the CEM connector as per illustration.
Carefully pull on the wire to check that it is secured. Push the catch (A) back into place. Reinstall the connector in the CEM. Check that the connector is
secure.
Reinstall the connector in the CEM. Check that the connector is secure.
