V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Install and connect the cable harness connector to the bracket. Ensure that the cable harness is correctly positioned. Clamp the cable harness with tie
straps.
Installing / adjusting the gear position sensor
Install:
-
The holder / spacer on the cable harness grommet.
-
The screws for the holder / gear-shift position sensor. Do not tighten the screws.
-
The rubber washer, the lock washer and the nut for the gear shift linkage rod. Lock the nut with the washer.
Adjust the gear-shift position sensor.
Installing components
Install:
-
The dip stick pipe. Ensure that the O-ring is in position.
