V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Steering Angle Sensor: Service and Repair
Steering Wheel Module, Steering Wheel And Contact Reel, Replacement
Special tools: 998 8695
NOTE: During work that involves removing the steering wheel and/or contact reel, it is important that the steering wheel be installed such that it is
located correctly with regard to the front wheels and that the contact reel is set in the middle position. The contact reel is supplied in the middle position
with a locking screw installed. If this locking screw is unfastened the contact reel has to be zeroed again.
CAUTION: The battery must not be connected when the steering wheel module is removed or replaced.
WARNING: Under no circumstances use an ohmmeter or other live measuring instrument to measure the resistance in the steering wheel
module. The cabling may not be tested with a connected steering wheel module because this could be deployed.
Adjusting steering wheel position
-
The steering wheel position is adjusted in accordance with (B1), (B2), (B4), (B8) and (B9).
Preparations
-
Make a note of radio code if anti-theft coded radio installed.
-
Turn ignition off.
-
Disconnect battery negative lead.
Removing steering wheel module
-
Turn the ignition key to position I so that the steering wheel lock is disengaged.
-
Undo the two torx screws (Tx 30) on back of steering wheel.
-
Turn the steering wheel to access the screws.
-
Release the connector and remove the steering wheel module.
-
For handling a non-deployed steering wheel module.
Connecting special tool 998 8695 to the steering wheel module connector
