V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
There are two reference points (A) on the door and run-off profile. These points can be used to position the run-off profile correctly on the door.
Position the run-off profile on the door.
Use the run-off profile as a template. Mark the door to indicate the correct position for the run-off profile.
Apply the seal (P/N 277253) 1 cm inside the markings. See the illustration.
Note! The seal must be positioned beneath the drain hole (B) furthest down on the door.
Manual window mechanisms:
Press the run-off profile over the shaft for the window winder handle.
Power window mechanisms:
Route the cable harness through the slot
Carefully press the run-off profile into place.
Manual window mechanisms:
Close the slot using tape.
Install the bracket using two screws.
Installing door panels
Front side door:
Install the door panel according to Panel front side door See: Panel Front Side Door.
Rear side door:
Install the door panel according to The panel for the rear side door See: Rear Door/Rear Door Panel/Service and Repair/Removal and Replacement.
Panel Front Side Door
Panel front side door
Removing the panel from the front door