V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Paint: Service and Repair
Protective Film, Installing
Protective film, installing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Installation
Installing protective film
Protective film should be applied to the bodywork to avoid damage to the paintwork on the bodywork caused by the bumper cover.
Clean the surface under the bumper cover where the protective film is to be installed. See the illustration.
Use protective film P/N 951 1089.
Cut a piece that is 500 mm long (A) and 25 mm wide (B).
Install the protective film as illustrated. Start 5 mm from the tailgate / edge molding.
Ensure that there are no air bubbles between the protective film and the bodywork.