V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
result in loads to the pad and/or wire that damage the pad. (The type of seam on the upholstery may cause wear in the long term.)
The Surface Of The Heater Pad During Installation
CAUTION: There must not be any bubbles or kinks when the heater pad is bonded to the foam filling. Bubbles and kinks increase the risk of damage to
the pad during use. This applies to the entire surface, but to the heating wires in particular.
Finishing Work After The Heater Pad Has Been Bonded Into Place
