V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
the rear heated oxygen sensor (HO2S) (count the number of turns)
-
the rear engine cover
-
Slacken off the clamp around the rear exhaust pipe
-
the nuts. Remove the front exhaust pipe
-
the gasket
-
the front exhaust pipe from the rear exhaust pipe.
Installing the front exhaust pipe
-
Clean the mating surfaces
-
Position the end of the front pipe in the rear pipe
-
Install a new gasket. Tighten the front pipe to the Three Way catalytic converter (TWC). Tighten the nuts. Tighten to 25 Nm
-
Hang up the exhaust system. Tighten the clamp on the rear exhaust pipe. Tighten to 60 Nm
-
Install the rear engine cover
-
Install the rear floor hatch. Use grease, P/N: 1161408. Turn the heated oxygen sensor (HO2S) the same number of turns as when removing it.
Tighten to 55 Nm.