V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Blower Motor: Procedures
Removing the Fan (Fan Housing Removed)
Removing The Fan (Fan Housing Removed)
-
Remove the soundproofing panel on the passenger side.
-
If the car is equipped with an alarm, remove the screw and slide the "Ultrasonic and glass breakage control modules" to one side.
-
Disconnect the connector from the blower fan motor.
-
Cut 10 x 7 cm in the insulation panel and bend the panel.
-
Remove three screws.
-
Pull the motor down and pull it out (turn the motor 90 degrees).
Installation
-
Check the seals.
-
Install the motor using a twisting movement.
-
Install three screws.
-
Connect the connector for the blower fan motor.
-
If the car is equipped with an alarm, install "the ultrasonic and glass breakage control modules" and the screw.
-
Install the insulation panel and secure it with tape.
-
Check the function.
-
Install the soundproofing panel on the passenger side.
Blower Fan Housing
Removing The Blower Fan Housing