V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Transfer the components (foam, rubber etc.) to the new condenser.
Position the condenser. Tighten to 10 Nm.
Secure the radiator at the support. Tighten to 10 Nm.
Remove the seals.
Lubricate the new O-rings with compressor oil.
Install the pipes. Tighten the pipes. Tighten to 25 Nm.
Filling and checking
Fill and check the system according to Pipes and hoses See: Hose/Line HVAC/Service and Repair/Removal and Replacement.
Removal, Replacement and Installation
Condenser
Special tools:
999 5474 RADIATOR PROTECTION See: Tools and Equipment/999 5474 Radiator Protection
Warning! Follow the safety rules for work with the heating/ventilation system, see Safety instructions when handling refrigerant See: Service
Precautions/Technician Safety Information/Safety Instructions When Handling Refrigerant
Read the instruction about slow and fast leakage.
General
Note! Always change O-rings when replacing condenser.
Drain the refrigerant from the system, see Draining See: Service and Repair/Draining
Remove the pipe between condenser and dryer