V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Turn Signal Lamp: Procedures
Turn signal lamps
-
Slacken off the screw holding the lamp two turns.
-
Hold in the catches. Pull the lamp housing forwards.
-
Disconnect the bulb holder.
-
Reinstall in reverse order.
-
Check the function.
Side Turn Signal Flashers
-
The bulb and the bulb holder are replaced from the outside.
-
Remove the bulb holder by pressing off the retaining clip at the front edge as illustrated. Use a 0.3 mm feeler gauge.
HINT: Stick a piece of tape on the side of the feeler gauge. This is to prevent damage to the paintwork. Press the feeler gauge against the front fender.
Bulbs And Holders
