V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Install a new sealing ring. Apply installation paste (P/N 1161035-9) to the entire length of the screw thread.
Tighten the heated oxygen sensor (HO2S). Tighten to 55 Nm
-
Pull the cable upwards.
Installing the heated oxygen sensor (HO2S), cable and connector
Note! Adjust the routing of the cable so that it does not come into contact with the exhaust system.
-
Route the cable. Secure the cable to the 3 mounting points
-
Connect the connector. Secure the cable to the bracket
-
Reinstall the relay cover.
Replacing Lambda Sond Rear
Replacing lambda sond rear
Removing heated oxygen sensor (HO2S) wiring