V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Carefully check the rubber seal. Apply a small amount of petroleum jelly to the rubber seal.
-
Ensure that the pressure sensor is the correct way up. Then press the pressure sensor down into the charge air cooler (CAC).
-
Check that the two protruding edges (A) enclose the pressure sensor properly and hold the sensor in place.
-
Reinstall the nut. Tighten the nut. Tighten to 10 Nm. Reconnect the switch.
Finishing
-
Start the engine. Check for leakage.
-
Check that the pressure sensor for charge air is working correctly.
-
Read off the diagnostic trouble codes (DTCs). Then erase them.