V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
the lock nut for the front pin bolt for the control arm.
Tighten the screwed joint:
-
the long screws at the front edge. Tighten to 90 Nm
-
the short screws at the rear edge. Tighten to 90 Nm.
Remove the support and rock the car a few times so that the bushings come into the correct position.
Tighten the front pin bolt for the control arms. Tighten to 90 Nm + 60°.
Installing the steering gear housing
Install:
-
the steering gear in its mountings
-
the brackets and the screws. Tighten to 80 Nm.
Installing the pipe bracket